#Juniper networks network connect 8.0.9 generator

This is because the new management IP address will take effect at 99% resulting in a disconnected GUI session. Two cards were used for signaling (1 Gb interfaces each), and two cards were used for media (10 Gb interfaces each).

#Juniper networks network connect 8.0.9 generator

The Spectra call generator a has 4 interfaces, with 2 cards each. Note:В When changing the management IP addressВ and committing, you will never see the commit operation complete. The SBC is connected to the public and private sides of the network through Juniper switch. Navigate to Device > Setup > Services,В Click edit and add a DNS server.Д¬lick OK and click on the commit button in the upper right to commit the changes.Navigate to Device > Setup > Interfaces > Management.Runtime link speed/duplex/state: 10000/full/upД¬onfigured link speed/duplex/state: auto/auto/auto Exit configuration mode by using the command exit and then confirm the configurations by running the command show interface management within configuration show interface management.Commit the changes using the command commit.Use the following command to set the IP address of the management set deviceconfig system ip-address netmask default-gateway dns-setting servers primary.Change the system setting to static (DHCP is enabled by set deviceconfig system type static.Enter configuration mode using the command configure.Login to the device with the default username and password (admin/admin).Before starting this procedure, please make sure a connection can be made via aВ console cable to theВ Palo Alto Networks device.